Difference between revisions of "ESP-RFID"
Jump to navigation
Jump to search
(→Setup) |
|||
| Line 9: | Line 9: | ||
* ESP-RFID firmware from [https://github.com/esprfid/esp-rfid GitHub] | * ESP-RFID firmware from [https://github.com/esprfid/esp-rfid GitHub] | ||
* a firmware flashing tool of your choice (on Windows not required) | * a firmware flashing tool of your choice (on Windows not required) | ||
* any necessary drivers that are needed for the microcontroller board of you choosing | |||
== Description == | == Description == | ||
Revision as of 09:09, 30 January 2023
Summary
Introduction to the ESP-RFID access control system
Requirements
- a ESP8266 microcontroller board with at least 4 MBytes flash memory or the official relay board
- a RC522, PN532, Wiegand, or RDM6300 RFID reader
- ESP-RFID firmware from GitHub
- a firmware flashing tool of your choice (on Windows not required)
- any necessary drivers that are needed for the microcontroller board of you choosing
Description
The ESP-RFID is an open-source RFID access control system that uses ESP8266 microcontroller board and one of the required RFID readers that is able to unlock doors. The administrator of the system is able to add up to 1000 users to the access controll system.
Setup
First you have to physically connect the RFID reader with the ESP8266 microcontroller board.
The pin connection can be taken from the following table.
| ESP8266 | NodeMcu/WeMos | Wiegand | PN532 | MFRC522 | RDM6300 |
|---|---|---|---|---|---|
| GPIO-15 | D8 | SS | SDA/SS | ||
| GPIO-13 | D7 | D0 | MOSI | MOSI | |
| GPIO-12 | D6 | D1 | MISO | MISO | |
| GPIO-14 | D5 | SCK | SCK | TX | |
| GPIO-04 | D2 | ||||
| GPIO-05 | D1 |
After
Webinterface
After the initial setup the ESP8266 microcontroller board broadcasts a public network
Used Hardware
Device to be used with this documentation Maybe another device to be used with this documentation
Courses
- A course where this documentation was used (2017, 2018)
- Another one (2018)