Difference between revisions of "Flipper Zero"
Jump to navigation
Jump to search
(WIP Wiki created) |
(Summary and setup) |
||
Line 1: | Line 1: | ||
== Summary == | |||
The Flipper Zero is a gadget for penetration testers, system administrators and tech enthusiasts created by Flipper Devices Inc. The device allows capturing and transmitting of various Sub-GHz signals, such as Garage Openers or NFC chips, as-well as Infrared signals. Furthermore the device can be used as a Bad USB Stick and offers iButton capabilities. | |||
Thanks to its small form factor it is a perfect device for covert operations. | |||
== Description == | |||
=== Setting up the Flipper Zero === | |||
# Open the box containing the Flipper Zero and boot it by holding down the back key | |||
# To use the full potential of the Flipper Zero an Micro SD-Card is needed. Insert it into the right bottom of the flipper with the pins of the SD-Card facing upwards. | |||
# After successful installation of the Micro SD-Card, a little SD-Card symbol appears on the top left of the Flipper Zero GUI. | |||
# Finally for the best experience the Firmware should be updated, this point is explained in more detail in the section "Firmware Update". |
Revision as of 10:17, 10 February 2023
Summary
The Flipper Zero is a gadget for penetration testers, system administrators and tech enthusiasts created by Flipper Devices Inc. The device allows capturing and transmitting of various Sub-GHz signals, such as Garage Openers or NFC chips, as-well as Infrared signals. Furthermore the device can be used as a Bad USB Stick and offers iButton capabilities. Thanks to its small form factor it is a perfect device for covert operations.
Description
Setting up the Flipper Zero
- Open the box containing the Flipper Zero and boot it by holding down the back key
- To use the full potential of the Flipper Zero an Micro SD-Card is needed. Insert it into the right bottom of the flipper with the pins of the SD-Card facing upwards.
- After successful installation of the Micro SD-Card, a little SD-Card symbol appears on the top left of the Flipper Zero GUI.
- Finally for the best experience the Firmware should be updated, this point is explained in more detail in the section "Firmware Update".